Raspberry Pi - RHF0M301 LoRa Gateway Shield
author: async
2 layer board of 1.55 x 2.11 inches (39.4 x 53.5 mm)
Uploaded:
June 14, 2017
Shared:
July 17, 2017
Total Price:
$16.30
RHF0M301 – LoRa Gateway and Concentrator Module Shield for Raspberry Pi
RHF0M301 – LoRa Gateway and Concentrator Module Shield for Raspberry Pi
breakout r001b
author: bryce.himebaugh
4 layer board of 3.00 x 1.95 inches (76.2 x 49.5 mm)
Uploaded:
July 17, 2017
Shared:
July 17, 2017
Total Price:
$58.50
Avian Monitor Software Development Board: This board is used to develop software and measure power for components that will be used on the avian monitoring tags.
Avian Monitor Software Development Board: This board is used to develop software and measure power for components that will be used on the avian monitoring tags.
OCXO-REF-1.01.brd
author: petesoper
2 layer board of 2.00 x 1.75 inches (50.8 x 44.5 mm)
Uploaded:
July 07, 2017
Shared:
July 17, 2017
Total Price:
$17.50
Oven controlled oscillator board with 5 and 3.3v regulators. Details here
Oven controlled oscillator board with 5 and 3.3v regulators. Details here
Sensor Driver
author: MatthewOslin
2 layer board of 1.00 x 1.00 inches (25.4 x 25.4 mm)
Uploaded:
July 17, 2017
Shared:
July 17, 2017
Total Price:
$5.00
47.5mm Q8 Texas Avenger driver with mounting holes
author: Texas_Ace
2 layer board of 1.88 x 1.88 inches (47.6 x 47.6 mm)
Uploaded:
July 16, 2017
Shared:
July 16, 2017
Total Price:
$17.55
This is the normal SRK / Q8 driver in 47.5mm size and with the Q8 mounting holes. Only really useful for the Q8. You might need to leave some of the 7135's off in order to clear the mounting tabs on the Q8.
This is the normal SRK / Q8 driver in 47.5mm size and with the Q8 mounting holes. Only really useful for the Q8. You might need to leave some of the 7135's off in order to clear the mounting tabs on the Q8.
17mm TA driver with less vias
author: Texas_Ace
2 layer board of 0.68 x 0.68 inches (17.2 x 17.2 mm)
Uploaded:
July 16, 2017
Shared:
July 16, 2017
Total Price:
$2.25
This is the same as the normal 17mm TA driver but with less vias under the FET. This makes a short less likely when soldering on the ground wire for the LED but also increases resistance a bit. Both will work just fine and are exactly the same in every other way.
This is the same as the normal 17mm TA driver but with less vias under the FET. This makes a short less likely when soldering on the ground wire for the LED but also increases resistance a bit. Both will work just fine and are exactly the same in every other way.
