Shared Projects

DIY option to add LED indication under guitar pedal footswitch pedal washer. Drill 15mm holes for footswitch, put LED ring inside enslosure where lock washer would normally go, add thin clear vinyl washer for insulation; LEDs should shine through white nylon washer on top.

DIY option to add LED indication under guitar pedal footswitch pedal washer. Drill 15mm holes for footswitch, put LED ring inside enslosure where lock washer would normally go, add thin clear vinyl washer for insulation; LEDs should shine through white nylon washer on top. Order on Flex to get LED Indicator ring with flexible lead extensions–trim to your needs. Eliminates running wires through enclosure space to power LEDs. (Prototype, Unverified).

Introduction

This is a power regulator board for my MGBC (Pocket Color) project. This should work perfectly fine on a regular Game Boy Color or Pocket, but I haven’t exhaustively tested it.

Disclaimer

Please keep in mind, I haven’t fully tested this power board, so you accept any and all risks associated with using this board. That being said, it’s similar to a lot of other replacement Game Boy power supplies out there, with a few distinct differences.

Features

Some features of this power board include:

• Changing the power switch to a “soft power switch,” meaning the main power of the Game Boy does not flow through the switch
• Improved efficiency over the OEM regulator
• Improves the audio output of the Game Boy
• Bootloop protection circuitry to prevent overdischarge of AAA batteries, and to allow the Game Boy to die gracefully instead of violently stuttering until the regulator gives up

Using with a GBC or MGB

If you wish to use this on a GBC/MGB, you must:

• Remove U5 from the Game Boy circuit board (the DC/DC converter board) and replace it with this one. Make sure you have a header pin populated for pin 2 on the socket!
• On the main Game Boy PCB, add a wire from pin 2 of the U5 socket to the node labelled SW1-VCC. This node connects to the power switch and F1, so you can choose either points.
• If you are soldering a wire to the fuse directly, MAKE SURE YOU CHOOSE THE CORRECT SIDE. It must be the side that’s directly connected to the power switch. A multimeter will not tell you which side of the fuse is which if you have the fuse on the board.

Also note this will only work with IPS modded systems. There are no LCD power rails.

Bill of Materials

A PCB circuit board designed to mount the Sparkfun Codec Module with the Sparkfun ESP32 Thing Plus C. Includes a MIDI I/O interface along with convenient pads and header for connecting external controllers. This is an audio development project based on the ESP32 WROOM 32E processor with a WM8960 Codec.

With Effects software package and docs at https://www.jtalbert.xyz/ESP32/

RGB mux board to use on smaller CRTs. If you want to buy the full kit checkout my store. When you use this kit, you have to solder the board after you mount the 8pin mini din (MD8) connector to the CRT. See examples below.

Examples:

• Samsung CXF0933
• Sony KV-9PT50

https://source.puri.sm/eric.kuzmenko/scope-usb-diff-pair-probe

Intended to be used with Siglent SDS2000X Plus oscilloscopes.

Interface board from Arduino Mega programmer to 28 pin socket.

It’s a switch, and LED, and a nano, with a RF24 receiver. It blinks when told to, remotely.

Stereo Variable High Shelf Equalizer SVHSE

send pitch cv to your micromoog properly. tunable on the front panel.

2 x 4 to 1 unity gain mixers for audio or pitch cv. presice enough for transposing cv pitch sequences.