Shared Projects by FrankStrasser

Just a simple board to wire rgb from the encoder(of models of cdi consoles with the cxa1145 encoder)to your choice of connector(preferably an 8 pin mini din). To be used with a pass through scart cable with no components inside. The positive side of all the caps should be facing the resistors, the negative side of the caps should face the output pads.

A companion board for Tim Worthingtons nesrgb mod. This board is made to be soldered on top of an 8 pin mini din pcb mount connector which is soldered into the rf slot of an Nes frontloader for an easy no cut plastic rgb mod. Cover bottom except mounting holes and pins. Use an md 80sm mini din from mouser or digikey or similar uxcell version from amazon.

Same components used as my other cdi board just incorporates an 8 pin mini din. Made to be soldered into the rf space of a cdi 220 console. First, desolder the rf box. Then solder on components and din to the pcb, then flush cut and tape bottom. Then solder capacitor or resistor legs from bottom of the motherboard through the rf slots through top of motherboard. Then place pcb over top of the legs, align board, solder in, and flushcut the legs. Can use an md 80sm din from digikey or mouser or uxcell from Amazon. Install wiring guide at retro rgb .com