Shared Projects by FrankStrasser

Just a board to go along with tim worthingtons rgb mod of an av famicom. Just something to make doing rgb mods on a av famicom a little cleaner and more fun. Solder to the pins of the multiout like you would a snes rgb mod and this board just sends the rgbs signals to the multiout pins.

IMPORTANT PLEASE READ this is an adapter to make up to a 4MB sa1 snes game it adapts an m27c322-100s1 eprom to the pcb. Order .8 mil for best fit. Installation: First program the eprom. Then place the eprom inside the adapter as far down as it will go and flush cut the legs. Then solder the adapter to the cart pcb making sure all connections are good before preceding. Last, place the eprom in the adapter and solder the legs in the holes from the top of the adapter. These eproms are hard to find but you can get them by emailing barum electronics sales 09 @ barum electronics . com. To program the eprom, order my adapter on here that adapts the eprom for use with a gq4x.

Adapter for a gq 4x to use a m27c322-100s1 eprom. You need to source the zif socket or socket for it I used a sdip42 1.778 pin pitch zif socket.

ORDER .8MM OR IT WILL NOT FIT!! ram adapter for making a repro requiring ram like megaman minus infinity for nes with an mmc5 board. Set the ram chip all the way back in the adapter, lift the pins that have vias extending across them and solder them to the extended holes. The white hole designation via is for soldering to pin 47 of a jp mmc5 cart or 56 of a nes cart. Use a cap leg to put through and solder through the holes also do the same for pins 32 and 31.

Same as my sms2nes controller just with some extras. To replace a genesis controller pcb to use a genesis controller on a master system and when used with my pause reset board can pause and reset from controller. Has jumpers for either using a and b as 1 and 2 with c as reset or b and c as 1 and 2 with a as reset. When using a and b, holding c then pressing b will reset. When using b and c, holding a then pressing c will reset.