Shared Projects by FrankStrasser

ORDER .8 MM!!! This is an adapter to translate star ocean or using an sdd1 snes cart. Uses an m27c322 S1 chip which is smaller and a better fit than the huge f1. Use is same as my sa1 adapter. program the chip then place in adapter and flush cut legs then solder adapter to board making sure all connections are good then solder ic in. square notch is pin one. Program the chip with my adapter for the gq 4x also on this site to download. Get the chips from barum electronics they have plenty

Same as my other snes multiout connector for av famicom rgb mods or N64 mods with Tim Worthington’s Rgb kit just only has rgbs hookups, not all other hookups

Just a board to go along with tim worthingtons rgb mod of an av famicom. Just something to make doing rgb mods on a av famicom a little cleaner and more fun. Solder to the pins of the multiout like you would a snes rgb mod and this board just sends the rgbs signals to the multiout pins.

IMPORTANT PLEASE READ this is an adapter to make up to a 4MB sa1 snes game it adapts an m27c322-100s1 eprom to the pcb. Order .8 mil for best fit. Installation: First program the eprom. Then place the eprom inside the adapter as far down as it will go and flush cut the legs. Then solder the adapter to the cart pcb making sure all connections are good before preceding. Last, place the eprom in the adapter and solder the legs in the holes from the top of the adapter. These eproms are hard to find but you can get them by emailing barum electronics sales 09 @ barum electronics . com. To program the eprom, order my adapter on here that adapts the eprom for use with a gq4x.