Shared Projects by SparkyBobo

DMX Demonstrator Fixture Temp Sensor (DMX-FXT, Rev 1.0)

The Fixture Temp Sensor is a stand-alone PCB which holds a small SMD surface temperature sensor for use with LEDs. It provides an analog voltage out proportional to the temperature.

For details click [here](https://github.com/SparkyB…

DMX Demonstrator DMX-512 IO Module (DMX-IO1, Rev 1.7)

The DMX-512 IO Module is a stand-alone module which generates or receives a DMX-512 signal, allowing the DMS Demonstrator system to communicate with DMX-512-compatible equipment.

For details click [here](https://github.com/SparkyBobo/d…

DMX Demonstrator Control Pro Adapter (DMX-CPAD, Rev 1.3)

The Control-Pro Adapter is an Arduino Shield which provides the 3-wire data/clock signal to the Receiver (DMX-RX1) and encoded the data stream to control the brightness of 4 LEDs using the Control Pro (DMX-…

DMX Demonstrator Transmitter IO Interface (DMX-TX2, Rev 1.4)

The Transmitter IO Interface is an Arduino Shield which provides an IO extension port to connect to IO modules to the transmitter.

For details click [here](https://github.com/SparkyBobo/dmxdemonstrator/tree/master/hardware/trans…

DMX Demonstrator Constant Current LED Driver (DMX-DCC, Rev 1.1)

The Constant Current LED Driver is stand-along module which takes 2 logic signals and amplifies the output for a larger current load such as an led chip.

For details click [here](https://github.com/SparkyBobo/dmxdemonstrator/…