Shared Projects by CaptainMurdoch

Adapter board to attach i2c based OLED displays to the Raspberry Pi. Only pins 1,3,5,9 are used on the Pi, others may be left unconnected or a smaller header could be used.

The board is designed to be used with two different OLED pinouts, VCC-GND-SCL-SDA and GND-VCC-SCL-SDA. Select a pinout by creating two solder bridges as noted on the board. Solder bridge between the GND and 1 holes to put GND on pin 1 of the 4-pin header, bridge between GND and 2 to put GND on pin 2. Do the same for VCC.

NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.

This board allows plugging a Raspberry Pi into a HUB75 compatible LED panel. The 26-pin female header for the Pi and the 16-pin tall stacking header for the HUB75 panel both attach to the back/bottom side of the board. The PCB hangs over the edge of the Pi and allows the Pi to plug directly into the back of the HUB75 panel. Pin 1 for the Pi is on the left bottom of the connector when viewed from the top of the board. Pin 1 for the HUB75 interface is the top right of the board. This PCB may also be used with a male header for the HUB75 panel attached to the top side of the board rather than a female header attached to the bottom side of the board.

NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.

This board allows plugging a set of HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The outputs are duplicates of each other, both outputs will display the same data. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male headers for the HUB75 connections attach to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.

NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.

This board allows plugging a HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male header for the HUB75 connection attaches to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.