Raspberry Pi Hub75 v1.1
author: CaptainMurdoch
2 layer board of 1.44 x 0.65 inches (36.5 x 16.5 mm)
Uploaded:
February 06, 2015
Shared:
February 06, 2015
Total Price:
$4.65
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male header for the HUB75 connection attaches to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male header for the HUB75 connection attaches to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.
