Raspberry Pi Hub75-Dual v1.1
author: CaptainMurdoch
2 layer board of 1.44 x 1.00 inches (36.5 x 25.4 mm)
Uploaded:
February 06, 2015
Shared:
February 06, 2015
Total Price:
$7.15
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a set of HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The outputs are duplicates of each other, both outputs will display the same data. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male headers for the HUB75 connections attach to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.
NOTE: This board uses the OLD pinout and the rpi-rgb-led-matrix library must be specifically compiled to work with this version. If you are a FPP user, check on the forums before ordering any of this board.
This board allows plugging a set of HUB75 compatible LED panel into the GPIO header on a Raspberry Pi. The outputs are duplicates of each other, both outputs will display the same data. The 26-pin female header for the Pi attaches to the back/bottom side of the board and the 16-pin male headers for the HUB75 connections attach to the top. Pin 1 is on the left bottom of each of the headers when viewed from the top of the board.
