Simple RF Bandpass Filter
author: SmittyHalibut
2 layer board of 1.96 x 1.16 inches (49.7 x 29.4 mm)
Uploaded:
December 22, 2016
Shared:
December 23, 2016
Total Price:
$11.30
A simple RF Bandpass Filter. Component values are dependent on your filter requirements.
This board will work with many Bandpass filter designs, such as https://www.electronicproducts.com/Bandpass_Filter_Design_Calculator.aspx . Put in your cut-off frequency, impedance is probably 50 ohms, and 5 L/C pairs. Then click Calculate, and those are your component values.
This board will take either 1206 SMT capacitors, or .1" radial capacitors. It’s laid out assuming FT37-43 toroids for the inductors, but will probably work with axial pre-made inductors too, they just won’t lay flat on the board. The SMA connectors will take either vertical or edge mounted SMA connectors.
A simple RF Bandpass Filter. Component values are dependent on your filter requirements.
This board will work with many Bandpass filter designs, such as https://www.electronicproducts.com/Bandpass_Filter_Design_Calculator.aspx . Put in your cut-off frequency, impedance is probably 50 ohms, and 5 L/C pairs. Then click Calculate, and those are your component values.
This board will take either 1206 SMT capacitors, or .1" radial capacitors. It’s laid out assuming FT37-43 toroids for the inductors, but will probably work with axial pre-made inductors too, they just won’t lay flat on the board. The SMA connectors will take either vertical or edge mounted SMA connectors.
