tBoard_v_0_3
author: burntCrispy
2 layer board of 2.48 x 1.38 inches (63.0 x 35.0 mm)
Uploaded:
July 02, 2025
Shared:
July 02, 2025
Total Price:
$17.05
Dumb tool board for Jubilee Baby Bullet.
Not Tested, should work with Baby Bullet + Orbiter 1.5 + E3D V6 Groovemount or Threaded Heatsink, Revo Micro should use v0_4 as fan connector is different
Uses Molex Micro-Fit 3.0:
- 1x 430451200 12p right angle for input from controller
- 1x 430251200 12p Housings to plug into this board
- 12x 430300007 Crimps for above housing, order extra just incase
- 2x 436500200 2p right angle for Temp and Fan
- 1x 436500227 2p straight for Heater
Molex KK or compatible 2.5mm, also need matching housing and crimps:
- 1x 4pin right angle for stepper
- 2x 2pin right angle for PFan and PFan2 (2 Part Fans)
v_0_3
- Made lower section narrower for threaded heatsinks version
12 pin layout Microfit 3.0 43025-1200
Stepper1 | Stepper2 | Stepper3 | Stepper4 | Heater- | Heater+ |
---|---|---|---|---|---|
Temperature | Temperature | PartFan- | PartFan+ | Fan- | Fan+ |
Clip | Clip |
Dumb tool board for Jubilee Baby Bullet.
Not Tested, should work with Baby Bullet + Orbiter 1.5 + E3D V6 Groovemount or Threaded Heatsink, Revo Micro should use v0_4 as fan connector is different
Uses Molex Micro-Fit 3.0:
- 1x 430451200 12p right angle for input from controller
- 1x 430251200 12p Housings to plug into this board
- 12x 430300007 Crimps for above housing, order extra just incase
- 2x 436500200 2p right angle for Temp and Fan
- 1x 436500227 2p straight for Heater
Molex KK or compatible 2.5mm, also need matching housing and crimps:
- 1x 4pin right angle for stepper
- 2x 2pin right angle for PFan and PFan2 (2 Part Fans)
v_0_3
- Made lower section narrower for threaded heatsinks version
12 pin layout Microfit 3.0 43025-1200
Stepper1 | Stepper2 | Stepper3 | Stepper4 | Heater- | Heater+ |
---|---|---|---|---|---|
Temperature | Temperature | PartFan- | PartFan+ | Fan- | Fan+ |
Clip | Clip |