Compact Atari Punk
author: Stormbolter
2 layer board of 1.04 x 1.09 inches (26.3 x 27.6 mm)
Uploaded:
December 25, 2017
Shared:
December 25, 2017
Total Price:
$5.60
This is a board for a Stepped Tone Generator (also known as Atari Punk).
Bill Of Materials
| Location | Type | Quantity | Notes |
|---|---|---|---|
| B500K | Panel-mounted 500K linear potentiometer | 2 | I used P160KNP-0QC20B500K |
| 9V | Switched 9V source of power | 1 | I used an ON-ON switch soldered to the positive of a 9V battery holder |
| SPK | 8 ohm Speaker | 1 | I used Visaton K36WP. You can solder a panel mounted audio out instead. |
| R1K | 1k ohm resistor | 1 | — |
| R10 | 10 ohm resistor | 1 | Replace by higher value if you feel your speaker is too loud, or by a 10klog pot if you want volume control. |
| C104 | 100nf Ceramic Capacitor (104) | 2 | — |
| C476 | 4.7uf Electrolytic Capacitor | 1 | — |
This is a board for a Stepped Tone Generator (also known as Atari Punk).
Bill Of Materials
| Location | Type | Quantity | Notes |
|---|---|---|---|
| B500K | Panel-mounted 500K linear potentiometer | 2 | I used P160KNP-0QC20B500K |
| 9V | Switched 9V source of power | 1 | I used an ON-ON switch soldered to the positive of a 9V battery holder |
| SPK | 8 ohm Speaker | 1 | I used Visaton K36WP. You can solder a panel mounted audio out instead. |
| R1K | 1k ohm resistor | 1 | — |
| R10 | 10 ohm resistor | 1 | Replace by higher value if you feel your speaker is too loud, or by a 10klog pot if you want volume control. |
| C104 | 100nf Ceramic Capacitor (104) | 2 | — |
| C476 | 4.7uf Electrolytic Capacitor | 1 | — |
