Rx5808 fpv receiver V1.1

author: spikey
Top
Bottom

2 layer board of 1.59 x 1.50 inches (40.3 x 38.1 mm)
Uploaded: December 13, 2015
Shared: February 10, 2016
Total Price: $11.90

Same as previous, just a bit smaller. FPV receiver, based on rx5808 PRO.
unmodded rx5808 from ebay

Modded rx5805 Module is needed to enable SPI. the switch on the bottom of the PCB is to switch between atmega-generated “config” and “FPV” screen. ISP programming header on test pads. Parst List. VIN should be 5-16V.

I still have a couple of blank boards, that I have no use of. Shoot me an email.

here are two renderings Alt text Alt text

Same as previous, just a bit smaller. FPV receiver, based on rx5808 PRO.
unmodded rx5808 from ebay

Modded rx5805 Module is needed to enable SPI. the switch on the bottom of the PCB is to switch between atmega-generated “config” and “FPV” screen. ISP programming header on test pads. Parst List. VIN should be 5-16V.

I still have a couple of blank boards, that I have no use of. Shoot me an email.

here are two renderings Alt text Alt text

Top
Bottom
  • Actions

      Ordering shared project

      Hey there! Before ordering, make sure you have all the info you need to complete and use this design. This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
      Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended. OSH Park cannot place any guarantees about the functionality or correctness of the design.
      Order Board
    • Order Board
    • Download
    • Permalink
    • Embed link
Embeddable link to order this shared Project
Whaleshark white
© Copyright 2024 OSH Park, LLC | Privacy