Shared Projects by spikey

Shared Projects by spikey

ArduPilot on PiZero

2 layer board of 2.67 x 1.19 inches (67.7 x 30.2 mm)
Uploaded: December 24, 2016
Shared: January 24, 2017
Total Price: $15.80

Go here for instructions.

This one works, but I intend to post a new one, without ADS1115 smd. I will use modules, just to make life easier… and a project cheaper

Go here for instructions.

This one works, but I intend to post a new one, without ADS1115 smd. I will use modules, just to make life easier… and a project cheaper

Embeddable link to order this shared Project

Rx5808 fpv receiver V1.1

2 layer board of 1.59 x 1.50 inches (40.3 x 38.1 mm)
Uploaded: December 13, 2015
Shared: February 10, 2016
Total Price: $11.90

Same as previous, just a bit smaller. FPV receiver, based on rx5808 PRO.
unmodded rx5808 from ebay

Modded rx5805 Module is …

Show full description

Same as previous, just a bit smaller. FPV receiver, based on rx5808 PRO.
unmodded rx5808 from ebay

Modded rx5805 Module is …

Show full description

Embeddable link to order this shared Project

CC3D barometer, compass, gps, OLED addon board

2 layer board of 1.42 x 1.42 inches (36.0 x 36.0 mm)
Uploaded: May 04, 2015
Shared: May 04, 2015
Total Price: $10.05

Barometer, magnetometer, GPS and I2C breakout board for CC3D on Cleanflight. You can also plug in an OLED display and GPS. Board size is the same as CC3D (36x36mm), and so is the hole placement (30,5mm apart). [Measurements (link to wiki.Openpilot.org)](https://wiki.openpilot.org/download/attachm…

Show full description

Barometer, magnetometer, GPS and I2C breakout board for CC3D on Cleanflight. You can also plug in an OLED display and GPS. Board size is the same as CC3D (36x36mm), and so is the hole placement (30,5mm apart). [Measurements (link to wiki.Openpilot.org)](https://wiki.openpilot.org/download/attachm…

Show full description

Embeddable link to order this shared Project