SNES 32Mb TSOP-DIP Frontside Adapter - Rev.A
author: ziggy587
2 layer board of 1.82 x 0.73 inches (46.2 x 18.5 mm)
Uploaded:
December 15, 2024
Shared:
December 15, 2024
Total Price:
$6.60
NOT TESTED!
This is a TSOP adapter that is meant to replace the mask ROM on a SNES cart.
For a 32Mb game, use two 29F160 flash chips along with a 74'00 TSOP. Leave J1 open. For a 24Mb game, you should be able to use a 29F160 for U1 and a 29F800 for U2.
For a 16Mb game or smaller, use a single TSOP (29F160, 29F800, 29F400) chip in the U1 position, do not install the 74'00, and you must close J1.
C1, C2 and C3 are 0.01μF 0603 capacitors.
For J1, you should be able to close it with a solder blob. It’s a standard 0805 pad size, so you could alternatively use a 0 ohm 0805 or 0603 resistor if you wish.
Use standard 2.54mm single row pin headers.
Please use responsibly.
NOT TESTED!
This is a TSOP adapter that is meant to replace the mask ROM on a SNES cart.
For a 32Mb game, use two 29F160 flash chips along with a 74'00 TSOP. Leave J1 open. For a 24Mb game, you should be able to use a 29F160 for U1 and a 29F800 for U2.
For a 16Mb game or smaller, use a single TSOP (29F160, 29F800, 29F400) chip in the U1 position, do not install the 74'00, and you must close J1.
C1, C2 and C3 are 0.01μF 0603 capacitors.
For J1, you should be able to close it with a solder blob. It’s a standard 0805 pad size, so you could alternatively use a 0 ohm 0805 or 0603 resistor if you wish.
Use standard 2.54mm single row pin headers.
Please use responsibly.
