Dual Pi CAN HAT
author: dewhisna
4 layer board of 2.57 x 1.19 inches (65.2 x 30.2 mm)
Uploaded:
September 30, 2017
Shared:
November 11, 2017
Total Price:
$30.40
Dual CAN Interface HAT specifically designed for the Raspberry Pi Zero W. However, it can be used on any of the Raspberry Pi boards, even those with the smaller I/O header, as apart from the HAT EEPROM, only the first 26-pins are used.
NOTE: This board mounts upside-down on top of the Raspberry Pi, with the NSD10-12S5 Isolated power supply module that goes on the bottom of this board on the outside of the stack. So pay attention to the orientation of the J1 connector connecting to the RPi.
Dual CAN Interface HAT specifically designed for the Raspberry Pi Zero W. However, it can be used on any of the Raspberry Pi boards, even those with the smaller I/O header, as apart from the HAT EEPROM, only the first 26-pins are used.
NOTE: This board mounts upside-down on top of the Raspberry Pi, with the NSD10-12S5 Isolated power supply module that goes on the bottom of this board on the outside of the stack. So pay attention to the orientation of the J1 connector connecting to the RPi.
