P-3669 Mahr Holder Charging V1
author: SW_AGengineer
2 layer board of 1.91 x 0.65 inches (48.5 x 16.6 mm)
Uploaded:
February 15, 2024
Shared:
February 15, 2024
Total Price:
$6.20
Board for custom charging of Mahr SF unit when on the tool stand. The relay, a TXD2SA-9V-X, will cut the connection to the unit unless power is applied to the input pins.
Inputs are clearance holes for 6mmx1 thread. A spring plunger (84995A41 from McMasterCarr) is used to create contact with the tool stand side and a nut to secure to the board. A plastic housing should be used to avoid shorting.
Outputs are wire pads for 24awg wire.
The assembly should be potted or covered as the live connections will be exposed.
Board for custom charging of Mahr SF unit when on the tool stand. The relay, a TXD2SA-9V-X, will cut the connection to the unit unless power is applied to the input pins.
Inputs are clearance holes for 6mmx1 thread. A spring plunger (84995A41 from McMasterCarr) is used to create contact with the tool stand side and a nut to secure to the board. A plastic housing should be used to avoid shorting.
Outputs are wire pads for 24awg wire.
The assembly should be potted or covered as the live connections will be exposed.
