Gerber_PCB_THS7374 buffer for CPLD_2021-05-27(1)
author: the_crayon_king
2 layer board of 1.22 x 1.04 inches (31.0 x 26.4 mm)
Uploaded:
May 27, 2021
Shared:
May 27, 2021
Total Price:
$6.35
This is to interface with a mod kit I have. If you want to use SEGA cables or just have a LPF then this is your best bet.
Set the pad named “LPF” to turn on a low pass filter (may do something idk).
If you are doing the SEGA cable thing then solder down the three jumpers you see by the outputs. Then your SEGA cable should act like it would for mods that remove the 75 ohm series resistance. This is the same width/layout as the mod kit.
Keep in mind anyone who might stumble upon this., do not remove any resistors on the mod kit (this board is not the mod kit; just a simple video buffer).
Refer to: https://atariage.com/forums/topic/311814-rgbypbpr-intellivision-thoughts/page/9/#comments
This is to interface with a mod kit I have. If you want to use SEGA cables or just have a LPF then this is your best bet.
Set the pad named “LPF” to turn on a low pass filter (may do something idk).
If you are doing the SEGA cable thing then solder down the three jumpers you see by the outputs. Then your SEGA cable should act like it would for mods that remove the 75 ohm series resistance. This is the same width/layout as the mod kit.
Keep in mind anyone who might stumble upon this., do not remove any resistors on the mod kit (this board is not the mod kit; just a simple video buffer).
Refer to: https://atariage.com/forums/topic/311814-rgbypbpr-intellivision-thoughts/page/9/#comments
