DM103R2
author: danmc
2 layer board of 1.04 x 1.04 inches (26.3 x 26.3 mm)
Uploaded:
April 14, 2017
Shared:
February 02, 2018
Total Price:
$5.35
10 mm to 1" Mallory Cap Adapter.
This is used to allow Nichicon LGX and LGY series capacitors to be mounted on a board which was originally for Mallory 1" diameter electrolytic caps. In my case this was to repair a Tektronix 7613 oscilloscope mainframe which had bad capacitors on the rectifier board. Note that this particular scope has two physical sizes of capacitors. This is the smaller one.
The 5 pins which replace the pins from the original capacitor are Harwin, Inc. H2101-01 pins which are digikey 952-1433-ND. Note that this pin is pretty skinny compared to the original Mallory capacitor pin so it will take a little soldering effort on the Tektronix board side.
10 mm to 1" Mallory Cap Adapter.
This is used to allow Nichicon LGX and LGY series capacitors to be mounted on a board which was originally for Mallory 1" diameter electrolytic caps. In my case this was to repair a Tektronix 7613 oscilloscope mainframe which had bad capacitors on the rectifier board. Note that this particular scope has two physical sizes of capacitors. This is the smaller one.
The 5 pins which replace the pins from the original capacitor are Harwin, Inc. H2101-01 pins which are digikey 952-1433-ND. Note that this pin is pretty skinny compared to the original Mallory capacitor pin so it will take a little soldering effort on the Tektronix board side.
