10 mm to 1-3/8" Mallory Cap Adapter

This is used to allow Nichicon LGX and LGY series capacitors to be mounted on a board which was originally for Mallory 1" diameter electrolytic caps. In my case this was to repair a Tektronix 7613 oscilloscope mainframe which had bad capacitors on the rectifier board. Note that this particular scope has two physical sizes of capacitors. This is the larger one. The 5 pins which replace the pins from the original capacitor are Harwin, Inc. H2101-01 pins which are digikey 952-1433-ND. Note that this pin is pretty skinny compared to the original Mallory capacitor pin so it will take a little soldering effort on the Tektronix board side.

10 mm to 1" Mallory Cap Adapter.

This is used to allow Nichicon LGX and LGY series capacitors to be mounted on a board which was originally for Mallory 1" diameter electrolytic caps. In my case this was to repair a Tektronix 7613 oscilloscope mainframe which had bad capacitors on the rectifier board. Note that this particular scope has two physical sizes of capacitors. This is the smaller one.

The 5 pins which replace the pins from the original capacitor are Harwin, Inc. H2101-01 pins which are digikey 952-1433-ND. Note that this pin is pretty skinny compared to the original Mallory capacitor pin so it will take a little soldering effort on the Tektronix board side.