GPS Pi Plate v0.1

author: nsayer
Top
Bottom

2 layer board of 1.05 x 1.35 inches (26.7 x 34.3 mm)
Uploaded: July 19, 2014
Shared: July 19, 2014
Total Price: $7.05

GPS serial and PPS for Raspberry Pi.

Takes an AdaFruit Ultimate GPS module and connects RX and TX to the GPIO serial pins (optionally - solder jumpers to disconnect them are on the board), the PPS output to GPIO 18, adds a CR1220 battery clip on the bottom for warm-start, a U.FL connector for an external GPS antenna and a FIX LED.

GPS serial and PPS for Raspberry Pi.

Takes an AdaFruit Ultimate GPS module and connects RX and TX to the GPIO serial pins (optionally - solder jumpers to disconnect them are on the board), the PPS output to GPIO 18, adds a CR1220 battery clip on the bottom for warm-start, a U.FL connector for an external GPS antenna and a FIX LED.

Top
Bottom
  • Actions

      Ordering shared project

      Hey there! Before ordering, make sure you have all the info you need to complete and use this design. This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
      Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended. OSH Park cannot place any guarantees about the functionality or correctness of the design.
      Order Board
    • Order Board
    • Download
    • Permalink
    • Embed link
Embeddable link to order this shared Project
Whaleshark white
© Copyright 2024 OSH Park, LLC | Privacy