UniFloppy Adapter
author: GRudolf94
2 layer board of 1.71 x 0.26 inches (43.4 x 6.6 mm)
Uploaded:
June 22, 2019
Shared:
June 22, 2019
Total Price:
$2.20
MIGHT REQUIRE MODDING TO INTERNAL METALWORK! Or just kludge as you wish
Meant initially for using a PC standard floppy drive on a Toshiba T3100, this might work with other devices using 26pin floppies. Verify pinouts for your case. Whatever was device specific, I left out to be made with solder bridges, cuts and wires. Add a shrouded header, a 26pin keyed female connector and a floppy Berg connector on wires for 5V feed to your FDD.
I HAVEN’T TESTED THIS YET!!! While it shouldn’t set your machine on fire, verify that 5V and GND aren’t shorted before powering up. I make no claims about the usability of this project, and any damage that may occur to your machine is your problem, and yours alone.
That said, I measured this thing at least three times.
MIGHT REQUIRE MODDING TO INTERNAL METALWORK! Or just kludge as you wish
Meant initially for using a PC standard floppy drive on a Toshiba T3100, this might work with other devices using 26pin floppies. Verify pinouts for your case. Whatever was device specific, I left out to be made with solder bridges, cuts and wires. Add a shrouded header, a 26pin keyed female connector and a floppy Berg connector on wires for 5V feed to your FDD.
I HAVEN’T TESTED THIS YET!!! While it shouldn’t set your machine on fire, verify that 5V and GND aren’t shorted before powering up. I make no claims about the usability of this project, and any damage that may occur to your machine is your problem, and yours alone.
That said, I measured this thing at least three times.
