P-3669 Mahr Holder Charging V2
author: SW_AGengineer
2 layer board of 1.91 x 0.65 inches (48.5 x 16.6 mm)
Uploaded:
February 16, 2024
Shared:
February 16, 2024
Total Price:
$6.20
Board for custom charging of Mahr SF unit when on the tool stand. The relay, a TXD2SA-9V-X, will cut the connection to the unit unless power is applied to the input pins.
Inputs are clearance holes for 6mmx1 thread. A spring plunger (84995A41 from McMasterCarr) is used to create contact with the tool stand side and a nut to secure to the board. A plastic housing should be used to avoid shorting.
Outputs are wire pads for 24awg wire.
The assembly should be potted or covered as the live connections will be exposed.
UPDATED: Added chamfers to board for machinability.
Board for custom charging of Mahr SF unit when on the tool stand. The relay, a TXD2SA-9V-X, will cut the connection to the unit unless power is applied to the input pins.
Inputs are clearance holes for 6mmx1 thread. A spring plunger (84995A41 from McMasterCarr) is used to create contact with the tool stand side and a nut to secure to the board. A plastic housing should be used to avoid shorting.
Outputs are wire pads for 24awg wire.
The assembly should be potted or covered as the live connections will be exposed.
UPDATED: Added chamfers to board for machinability.
