switchBoard-X3-LEDs-15
author: burntCrispy
2 layer board of 0.51 x 2.68 inches (13.1 x 68.1 mm)
Uploaded:
May 08, 2020
Shared:
June 05, 2020
Total Price:
$6.85
Board for 3 tact switches and 6 LEDs for back lighting.
Switches are wired between ground “-”, and the “1-3"pins. Config should be set to enable pull up resistors, and inverted.
RRF3.01 Example: `````‘M950 J0 C"!duex.e6stop"’
LEDs are connected between “-” “+"pins, 2 LEDs in parallel than a single resistor in series with them.
“+” pin is only used for the LEDs
Switches are on 15mm spacing.
BOM
- 3x Tact Switch 6x6mm 5mm Through Hole SPST-NO
- 6x 1206(3216) SMD LEDs
- 3x 805 SMD Resistors I used 100 ohm, which is safe for 5V and the possibility if one LED in the pair was mis-soldered, it won’t burn up the other.
- Connector 2.54mm 5 Pins Right Angle and corresponding plug and wire pigtails
Board for 3 tact switches and 6 LEDs for back lighting.
Switches are wired between ground “-”, and the “1-3"pins. Config should be set to enable pull up resistors, and inverted.
RRF3.01 Example: `````‘M950 J0 C"!duex.e6stop"’
LEDs are connected between “-” “+"pins, 2 LEDs in parallel than a single resistor in series with them.
“+” pin is only used for the LEDs
Switches are on 15mm spacing.
BOM
- 3x Tact Switch 6x6mm 5mm Through Hole SPST-NO
- 6x 1206(3216) SMD LEDs
- 3x 805 SMD Resistors I used 100 ohm, which is safe for 5V and the possibility if one LED in the pair was mis-soldered, it won’t burn up the other.
- Connector 2.54mm 5 Pins Right Angle and corresponding plug and wire pigtails
