Shared Projects by hydrabus

HydraBus_1_0_Shield_ESP_WROOM_32_V1_0_Rev1_1

HydraBus Shield / Breakout board for ESP-WROOM-32.

This shield can be used with or without HydraBus board, you can even cut HydraBus specific right side (on the line) to have a tiny ESP-WROOM-32 breakout board.

• This shield can be used on top or bottom of HydraBus board (you just need to solder ESP-WROOM-32 on top or bottom of the shield)

• The HydraBus board is a small (60mm x 37mm) and low cost, multi-tool extensible board with STM32F405 Cortex M4F 32bits MCU @168MHz with a fully open source firmware hydrafw and full online documentation hydrafw wiki

• The ESP-WROOM-32 is a low-power 32-bit 240 MHz dual core MCU Wi- Fi+BLE combo module that highly integrates TCP/IP network stacks, 12- bit ADC and HSPI/SDIO/UART/PWM/I2C/I2S interfaces. See ESP32 Overview, ESP-WROOM-32 link/info, Espressif Products Overview including ESP-WROOM-32 PDF

• Design based on official esp_wroom_32_datasheet_en.pdf (August 8, 2016)

The board has been tested (mainly UART with bridge mode of HydraBus/HydraFW) with an ESP-WROOM-32 soldered on bottom side and all work fine

There is only a typo on silkscreen on bottom side at left of IO15 which is labelled GND instead of IO13

See new version HydraESP32 HydraBus v1.0 Shield for ESP-WROOM-32 V1.1 Rev1.0 which fix that and improve a lot this breakout board

MagSpoof “wireless” credit card/magstripe spoofer by Samy Kamkar (I have just customized a bit the PCB) For more details see links: http://samy.pl/magspoof https://github.com/samyk/magspoof

Note: I have used L9110H IC (see datasheet https://www.elecrow.com/download/datasheet-l9110.pdf ) instead of old/obsolete L93D

The board has been tested and work perfectly

Based on Facedancer21 (By Travis Goodspeed) but smaller with improved routing, decoupling capacitor/USB traces for more details see original facedancer21

FaceDancer21+ Eagle/Gerber files are available on github

The board has been tested and work perfectly

HydraBus is an open source multi-tool hardware for anyone interested in Learning/Developping/Debugging/Hacking/Penetration Testing basic or advanced embedded hardware.

• The HydraBus board is a small (60mm x 37mm) and low cost, multi-tool extensible board with STM32F405 Cortex M4F 32bits MCU @168MHz with a fully open source firmware hydrafw and full online documentation hydrafw wiki

For more details see: hydrabus-1-0-specifications hydrabus github hydrafw github