Shared Projects by Taylor-MadeAK

This is a drop-in replacement PCB for original Super Nintendo/Super Famicom controllers that uses all through-hole components in a more beginner-friendly design. This design sacrifices the SOCD filter circuitry and lighted buttons of my other design in favor of using components that are easier to solder by hand.

IMPORTANT ASSEMBLY NOTE: It is very important to trim the resistor array legs as flush as possible on this design. The placement of these arrays overlaps some PCB supports on the inside of the front face of the controller housing, and not trimming these legs as flat as possible will result in difficulty closing the controller housing.

Complete assembly instructions.

This is a shoulder button PCB module for a Nintendo SNES controller. Designed to fit an OEM model controller, this may be compatible with many older and modern aftermarket models.

More information is available at the official repo for this project.

This is a replacement PCB for SNES controllers using readily available off-the-shelf parts with a focus on being hand-soldering friendly.

Features:

• Works just like the original, but better protected against ESD damage.

• OPTIONAL LEDs!

• OPTIONAL SOCD filter circuit for D-pad input.

Assembly instructions, BoM, and other documentation can be found on the main project site or in the public Codeberg repo.