MooLED 3.0 Final
author: Moo
2 layer board of 1.94 x 1.46 inches (49.3 x 37.1 mm)
Uploaded:
January 16, 2023
Shared:
January 16, 2023
Total Price:
$14.15
The final, compact version of the MooLED NeoPixel controller powered by WLED.
The 74AHCT125 4-channel signal buffer has been replaced by a pair of single channel variants, and the GPIO pins used for data and relay signalling have been reverted to the defaults used by WLED for the ESP32 (GPIO 16 and 12 respectively).
BOM: - ESP32 “D1 Mini” style development board, - 2 x TI SN74AHCT1G125 buffer (SOT-23-5), - 0603 470Ω resistor, - 10.5mm 1000uF electrolytic capacitor (10v or higher, whatever will fit), - G5LE style SPDT relay (5v coil voltage required!), - 3 pin MSTB style 5.08mm pluggable terminal connector, - 2 pin MSTB style 5.08mm pluggable terminal connector.
NOTE: There is no on-board fuse on this PCB. For larger current lighting projects using this board an in-line fuse between this controller and the power wire going to the LEDs will be necessary.
The final, compact version of the MooLED NeoPixel controller powered by WLED.
The 74AHCT125 4-channel signal buffer has been replaced by a pair of single channel variants, and the GPIO pins used for data and relay signalling have been reverted to the defaults used by WLED for the ESP32 (GPIO 16 and 12 respectively).
BOM: - ESP32 “D1 Mini” style development board, - 2 x TI SN74AHCT1G125 buffer (SOT-23-5), - 0603 470Ω resistor, - 10.5mm 1000uF electrolytic capacitor (10v or higher, whatever will fit), - G5LE style SPDT relay (5v coil voltage required!), - 3 pin MSTB style 5.08mm pluggable terminal connector, - 2 pin MSTB style 5.08mm pluggable terminal connector.
NOTE: There is no on-board fuse on this PCB. For larger current lighting projects using this board an in-line fuse between this controller and the power wire going to the LEDs will be necessary.
