Schematics, EAGLE and Gerber files, and other references here: https://drive.google.com/drive/folders/1CyXvsXiN4TgLzc1Nf8XQB_ZOHwcMmx7g?usp=sharing

Pretty much pulled from the datasheet and inspired by the circuitbenders.co.uk board.

BILL OF MATERIALS: - R1: 3 kOhm 1% Metal Film - C1: 0.1 uF 50v MLCC (C0G/NP0 or X7R) - I/O pads: either just wire or Phoenix 1729131 for terminals - Trim pot: Bourns 3296W-1-223LF (22 kOhm, 25k will work) - LTC1799 module - pads “2” and “3” go to a panel mount pot. You can use C100K or C500K for wider range of adjustment. I used this in an ART Multiverb and actually preferred the taper of audio/logarithmic pots over the reverse-log. If using the audio/log pot, run the wire from the pin 3 pad to pin 1 of the pot.

Here is a Mouser cart with all of the parts: https://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=683c34a120

Datasheet: https://www.analog.com/media/en/technical-documentation/data-sheets/LTC1799.pdf Circuitbenders version: https://www.circuitbenders.co.uk/forsale/LTC/LTCPCB.html