PC Engine TurboPad Controller Board, through hole
author: skum
2 layer board of 2.11 x 1.45 inches (53.7 x 36.9 mm)
Uploaded:
January 13, 2019
Shared:
January 13, 2019
Total Price:
$15.35
NOTE A mistake has been found, as the four “pre-count” legs on the HC163 are not tied to GND as they should. So if you made this board, you need to put a small wire between these and GND.
If you need to fix it, put a wire like shown on this crappy picture here:
A fixed version of the PCB here: https://oshpark.com/shared_projects/8Hmi1L9I
Based on the schematics found here: http://www.webalice.it/cicciopetito/
NOTE A mistake has been found, as the four “pre-count” legs on the HC163 are not tied to GND as they should. So if you made this board, you need to put a small wire between these and GND.
If you need to fix it, put a wire like shown on this crappy picture here:
A fixed version of the PCB here: https://oshpark.com/shared_projects/8Hmi1L9I
Based on the schematics found here: http://www.webalice.it/cicciopetito/
