X10 Control Board rev3

author: KC8UFV
Top
Bottom

2 layer board of 3.49 x 1.25 inches (88.6 x 31.8 mm)
Uploaded: October 06, 2019
Shared: October 06, 2019
Total Price: $21.80

Board sends an on/off command based on a switched pin turning on or off. The 3 pin headers are for the power interface - 1 (closest to edge) is the hot, 2 is the switched hot, and 3 is the neutral. This is based on the Microchip AN236 App Note, but using an ATMEGA328P for the main chip due to easier programming enviroment. The DIP switches set the house code and unit address. Code, schematics, and layout available on Github. https://github.com/kc8ufv/X10-Sender

Board sends an on/off command based on a switched pin turning on or off. The 3 pin headers are for the power interface - 1 (closest to edge) is the hot, 2 is the switched hot, and 3 is the neutral. This is based on the Microchip AN236 App Note, but using an ATMEGA328P for the main chip due to easier programming enviroment. The DIP switches set the house code and unit address. Code, schematics, and layout available on Github. https://github.com/kc8ufv/X10-Sender

Top
Bottom
  • Actions

      Ordering shared project

      Hey there! Before ordering, make sure you have all the info you need to complete and use this design. This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
      Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended. OSH Park cannot place any guarantees about the functionality or correctness of the design.
      Order Board
    • Order Board
    • Download
    • Permalink
    • Embed link
Embeddable link to order this shared Project
Whaleshark white
© Copyright 2025 OSH Park, LLC | Privacy