ESP8266-01 RemoteButton
author: RogerParkinson
2 layer board of 0.47 x 1.23 inches (12.0 x 31.2 mm)
Uploaded:
June 13, 2016
Shared:
July 05, 2016
Total Price:
$2.90
The board holds through hole connections for an ESP8266-01 and breakouts for an FDTI, VCC and GND. It is small enough to solder the ESP to and still leaves the ability to plug in an FDTI to reflash. There’s a jumper for GPIO0 and it uses the DTR from the FDTI to pull RST low. You can power the ESP from the FDTI by putting a jumper on JPVCC but the FDTI won’t provide enough power to actually run the ESP after flashing. The ‘Switch’ breakout uses CH_PD. Connect an n/o switch to this and the ESP can detect it. More detail at https://github.com/RogerParkinson/ESP8266-automation
The board holds through hole connections for an ESP8266-01 and breakouts for an FDTI, VCC and GND. It is small enough to solder the ESP to and still leaves the ability to plug in an FDTI to reflash. There’s a jumper for GPIO0 and it uses the DTR from the FDTI to pull RST low. You can power the ESP from the FDTI by putting a jumper on JPVCC but the FDTI won’t provide enough power to actually run the ESP after flashing. The ‘Switch’ breakout uses CH_PD. Connect an n/o switch to this and the ESP can detect it. More detail at https://github.com/RogerParkinson/ESP8266-automation
