[untested] Stepper Signal Breakout Board V0.3
author: Overtuner1
2 layer board of 0.80 x 0.57 inches (20.3 x 14.6 mm)
Uploaded:
February 05, 2016
Shared:
February 05, 2016
Total Price:
$2.25
small breakout board for using MCU pins on unused stepper sockets - especially when using more than one analog sensors on RADDS, more endstops than available onboard, fan or heater pwm outputs, whatever…
also connects the signals and power to the outputs - same way as the RRD Silencioso Adapter does.
fits RAMPS, RADDS and other controllers with sockets for standard A4988 and pin-compatible drivers
you should use a 3x3 right angle pinheader
V0.3 - moved conn for better wiring
small breakout board for using MCU pins on unused stepper sockets - especially when using more than one analog sensors on RADDS, more endstops than available onboard, fan or heater pwm outputs, whatever…
also connects the signals and power to the outputs - same way as the RRD Silencioso Adapter does.
fits RAMPS, RADDS and other controllers with sockets for standard A4988 and pin-compatible drivers
you should use a 3x3 right angle pinheader
V0.3 - moved conn for better wiring
