hs_wpi_test_board.kicad_pcb
author: ppelleti
2 layer board of 2.96 x 1.86 inches (75.1 x 47.1 mm)
Uploaded:
September 07, 2017
Shared:
October 05, 2017
Total Price:
$27.40
Test board for wiringPi Haskell binding, v1.2
This is a simple add-on board for Raspberry Pi. It is meant for testing the Haskell binding for wiringPi. It connects to the Raspberry Pi via a 40-pin ribbon cable, and has the following features:
wiringPi pins 0-7 are connected to yellow LEDs
wiringPi pins 26 and 23 are connected to red LEDs
wiringPi pins 21 and 22 are connected to each other (via a resistor to prevent short circuits) to allow for automated testing (i. e. an output pin sending to an input pin)
wiringPi pin 25 is connected to a momentary pushbutton which pulls it to ground via a resistor (so pin should be configured with an internal pullup)
See GitHub for more information and BOM.
Test board for wiringPi Haskell binding, v1.2
This is a simple add-on board for Raspberry Pi. It is meant for testing the Haskell binding for wiringPi. It connects to the Raspberry Pi via a 40-pin ribbon cable, and has the following features:
wiringPi pins 0-7 are connected to yellow LEDs
wiringPi pins 26 and 23 are connected to red LEDs
wiringPi pins 21 and 22 are connected to each other (via a resistor to prevent short circuits) to allow for automated testing (i. e. an output pin sending to an input pin)
wiringPi pin 25 is connected to a momentary pushbutton which pulls it to ground via a resistor (so pin should be configured with an internal pullup)
See GitHub for more information and BOM.
