Hi/Lo Current Sensor Combo Board
author: icenyne
2 layer board of 1.06 x 1.53 inches (26.9 x 38.9 mm)
Uploaded:
September 20, 2016
Shared:
September 20, 2016
Total Price:
$8.10
Current sensor board pair using TI’s INA250 and INA21x for high and low current measurements. Sensor board mounts up close to circuit under test, larger board provides connection for power and output signals, where an FPC cable connects the two.
Note: The holes for the banana plugs are a tad too large but will still hold in place. The footprint used for the INA21x was a tiny bit too large, so it doesn’t sit quite right on the pads but it can still be soldered into place.
Current sensor board pair using TI’s INA250 and INA21x for high and low current measurements. Sensor board mounts up close to circuit under test, larger board provides connection for power and output signals, where an FPC cable connects the two.
Note: The holes for the banana plugs are a tad too large but will still hold in place. The footprint used for the INA21x was a tiny bit too large, so it doesn’t sit quite right on the pads but it can still be soldered into place.
