USB Type-C JTAG Adapter

author: meklort
Top
Bottom

2 layer board of 0.95 x 1.69 inches (24.2 x 43.0 mm)
Uploaded: October 21, 2015
Shared: May 20, 2017
Total Price: $8.05

This board is a JTAG adapter based on an FTDI chip in a SD-card form factor.

Design has been tested with openocd and an Atmel SAMD5 board successfully. ***Note: This board does not properly specify the CC resistor for the USB Port, resulting in it not being detected properly with a usb-c to usb-c cable. A usb-c to USB-A cable works fine, however.

This board is a JTAG adapter based on an FTDI chip in a SD-card form factor.

Design has been tested with openocd and an Atmel SAMD5 board successfully. ***Note: This board does not properly specify the CC resistor for the USB Port, resulting in it not being detected properly with a usb-c to usb-c cable. A usb-c to USB-A cable works fine, however.

Top
Bottom
  • Actions

      Ordering shared project

      Hey there! Before ordering, make sure you have all the info you need to complete and use this design. This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
      Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended. OSH Park cannot place any guarantees about the functionality or correctness of the design.
      Order Board
    • Order Board
    • Download
    • Permalink
    • Embed link
Embeddable link to order this shared Project
Whaleshark white
© Copyright 2025 OSH Park, LLC | Privacy