Mitsubishi Heatpump (A/C) Controller v0.5 Adafruit Huzzah Feather Shield
author: endeavour
2 layer board of 2.00 x 0.90 inches (50.9 x 23.0 mm)
Uploaded:
May 05, 2019
Shared:
May 05, 2019
Total Price:
$9.05
This is a shield that fits on top of an Adafruit Huzzah Feather to facilitate it being neatly connected to a Mitsubishi Heatpump.
Parts required:
1 x Adafruit Huzzah Feather: https://www.adafruit.com/product/3046
2 x 10k resistors: https://uk.rs-online.com/web/p/through-hole-fixed-resistors/7077745/
1 x JST PA header: https://uk.rs-online.com/web/p/pcb-headers/5128490/
4 x JST PA jumper wires: https://www.digikey.co.uk/product-detail/en/jst-sales-america-inc/APAPA22K305/455-3086-ND/6009462
2 x JST female connectors PAP-05V-S: https://uk.rs-online.com/web/p/pcb-connector-housings/4766798/
If you want to be able to switch between the hardware serial and using GPIO pins 12/14 (software serial), you will need jumpers as below. Otherwise you can just solder the pins together.
2 x jumper headers: https://uk.rs-online.com/web/p/pcb-headers/4958470/
2 x jumpers: https://uk.rs-online.com/web/p/jumpers-shunts/6742397/
For more info see here: https://nicegear.nz/blog/hacking-a-mitsubishi-heat-pump-air-conditioner/
Get the software here: https://github.com/SwiCago/HeatPump
PROVIDED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT.
This is a shield that fits on top of an Adafruit Huzzah Feather to facilitate it being neatly connected to a Mitsubishi Heatpump.
Parts required:
1 x Adafruit Huzzah Feather: https://www.adafruit.com/product/3046
2 x 10k resistors: https://uk.rs-online.com/web/p/through-hole-fixed-resistors/7077745/
1 x JST PA header: https://uk.rs-online.com/web/p/pcb-headers/5128490/
4 x JST PA jumper wires: https://www.digikey.co.uk/product-detail/en/jst-sales-america-inc/APAPA22K305/455-3086-ND/6009462
2 x JST female connectors PAP-05V-S: https://uk.rs-online.com/web/p/pcb-connector-housings/4766798/
If you want to be able to switch between the hardware serial and using GPIO pins 12/14 (software serial), you will need jumpers as below. Otherwise you can just solder the pins together.
2 x jumper headers: https://uk.rs-online.com/web/p/pcb-headers/4958470/
2 x jumpers: https://uk.rs-online.com/web/p/jumpers-shunts/6742397/
For more info see here: https://nicegear.nz/blog/hacking-a-mitsubishi-heat-pump-air-conditioner/
Get the software here: https://github.com/SwiCago/HeatPump
PROVIDED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT.
