StepStick Breakout by zeroflow
author: zeroflow
2 layer board of 3.32 x 1.78 inches (84.3 x 45.3 mm)
Uploaded:
May 31, 2018
Shared:
May 31, 2018
Total Price:
$29.55
Stepstick-Breakout for the MKS sBase for upgrading the drivers
- VMOT: XT30 plug which can be chained to more boards
- Input Connectors: [E]nable, [S]tep, [D]ir, [Ground]
- Output Connectors: Same order as on the StepSticks
- VIO: Supply with you board’s IO Voltage (5V on RAMPS, 3.3V on MKS sBase, …)
- Capacitors between Motors: Just install what you think is right. 10µF 35V works for me. + and GND are marked.
- Inside each StepStick there are solder jumpers for MS1..3. Top row is VIO, middle row is MSx and bottom is GND.
- The unmarked pins between input (ESDG) and the StepStick are also the MS1..3 pins if you want to have a SPI bus for the TMC2130 drivers or use UART for TMC2208
Stepstick-Breakout for the MKS sBase for upgrading the drivers
- VMOT: XT30 plug which can be chained to more boards
- Input Connectors: [E]nable, [S]tep, [D]ir, [Ground]
- Output Connectors: Same order as on the StepSticks
- VIO: Supply with you board’s IO Voltage (5V on RAMPS, 3.3V on MKS sBase, …)
- Capacitors between Motors: Just install what you think is right. 10µF 35V works for me. + and GND are marked.
- Inside each StepStick there are solder jumpers for MS1..3. Top row is VIO, middle row is MSx and bottom is GND.
- The unmarked pins between input (ESDG) and the StepStick are also the MS1..3 pins if you want to have a SPI bus for the TMC2130 drivers or use UART for TMC2208
