DIY Wii Sensor Bar
author: hernan43
2 layer board of 3.56 x 0.36 inches (90.3 x 9.2 mm)
Uploaded:
November 03, 2019
Shared:
November 03, 2019
Total Price:
$6.40
I have no idea if this will work. This is for my own personal use. I used the LED series wizard at http://led.linear1.org/led.wiz to design the schematic.
I used a “manual” version of this and it did work fine. I’ve decided to try and make a PCB version so I can clip it to my laptop bezel. Uses a USB cable for power.
I included pads for the data portion of the cable just as a mechanical assist. They are not connected to anything.
Use this at your own risk.
I have no idea if this will work. This is for my own personal use. I used the LED series wizard at http://led.linear1.org/led.wiz to design the schematic.
I used a “manual” version of this and it did work fine. I’ve decided to try and make a PCB version so I can clip it to my laptop bezel. Uses a USB cable for power.
I included pads for the data portion of the cable just as a mechanical assist. They are not connected to anything.
Use this at your own risk.
