EasyRaceLapTimer Transponder SMD R1.2

author: TimJC
Top
Bottom

2 layer board of 0.36 x 0.72 inches (9.1 x 18.3 mm)
Uploaded: December 10, 2015
Shared: December 10, 2015
Total Price: $1.25

Please check out R1.4

IR transponder for multirotor (drone) racing with EasyRaceLapTimer system.

This board is intended to be powered by 5V from a spare servo connector on your receiver or flight controller. The hole in the board is for cable strain relief.

Note: ATTiny85 needs to be programmed with applicable code from EasyRaceLapTimer project.

This board has not been tested.

Parts to populate each board:

Optional (but recommended):

Helpful:

For more informaiton visit:

5V Through hole R1.1 version

Battery balance port R1.2 version

Please check out R1.4

IR transponder for multirotor (drone) racing with EasyRaceLapTimer system.

This board is intended to be powered by 5V from a spare servo connector on your receiver or flight controller. The hole in the board is for cable strain relief.

Note: ATTiny85 needs to be programmed with applicable code from EasyRaceLapTimer project.

This board has not been tested.

Parts to populate each board:

Optional (but recommended):

Helpful:

For more informaiton visit:

5V Through hole R1.1 version

Battery balance port R1.2 version

Top
Bottom
  • Actions

      Ordering shared project

      Hey there! Before ordering, make sure you have all the info you need to complete and use this design. This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
      Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended. OSH Park cannot place any guarantees about the functionality or correctness of the design.
      Order Board
    • Order Board
    • Download
    • Permalink
    • Embed link
Embeddable link to order this shared Project
Whaleshark white
© Copyright 2024 OSH Park, LLC | Privacy