EasyRaceLapTimer Transponder Through Hole R1.1
author: TimJC
2 layer board of 0.63 x 0.86 inches (16.0 x 21.8 mm)
Uploaded:
December 10, 2015
Shared:
December 10, 2015
Total Price:
$2.70
IR transponder for multirotor (drone) racing with EasyRaceLapTimer system.
This board is intended to be powered by 5V from a spare servo connector on your receiver or flight controller. The hole in the board is for cable strain relief.
Note: ATTiny85 needs to be programmed with applicable code from EasyRaceLapTimer project.
This board has not been tested.
Parts to populate each board:
Optional (but recommended): - DIP-8 Socket
For more informaiton visit:
IR transponder for multirotor (drone) racing with EasyRaceLapTimer system.
This board is intended to be powered by 5V from a spare servo connector on your receiver or flight controller. The hole in the board is for cable strain relief.
Note: ATTiny85 needs to be programmed with applicable code from EasyRaceLapTimer project.
This board has not been tested.
Parts to populate each board:
Optional (but recommended): - DIP-8 Socket
For more informaiton visit:
