Breadboard Power Feeder
author: Eric
2 layer board of 0.26 x 0.94 inches (6.5 x 23.8 mm)
Uploaded:
October 31, 2013
Shared:
January 10, 2014
Total Price:
$1.20
Cost: $1.20 for three.
Description:
Small board to feed power from your bench supply to a solderless breadboard.
Install a 2x2 pin header at one end, on the bottom side. Solder wires at the other end (positive to square pad). Terminate wires with red and black banana plugs. Install this slide switch on the top side. Use a small zip-tie around the notches to provide wire strain relief.
Cost: $1.20 for three.
Description:
Small board to feed power from your bench supply to a solderless breadboard.
Install a 2x2 pin header at one end, on the bottom side. Solder wires at the other end (positive to square pad). Terminate wires with red and black banana plugs. Install this slide switch on the top side. Use a small zip-tie around the notches to provide wire strain relief.
