PWM Pot with BAT54S Diode
author: BananaGuns
2 layer board of 0.32 x 0.40 inches (8.2 x 10.2 mm)
Uploaded:
June 12, 2016
Shared:
August 07, 2016
Total Price:
$0.60
Clean up your PWM builds by fitting the diodes right to the back of the pot. This also reduced the depth of the pot/diodeassemnly to about ¼ the size it is with the pins and diodes normally.
You don’t need to use a ½" potentiometer, pretty much any pot with a staggered footprint (shaped like a triangle) will work.
| Part | Package |
|---|---|
| 93PR10KLF | VSSOP8 |
| BAT54S | SOT23 |
Off board - One wire connects to the diode pad on your PWM board, the other connects to the Wiper pad. If the output is full power on 0, simply flip the wired around on the PWM board.
Be sure to follow me on Instagram:
@ApexBoxMods
And check out My eBay store for completed boards!
Clean up your PWM builds by fitting the diodes right to the back of the pot. This also reduced the depth of the pot/diodeassemnly to about ¼ the size it is with the pins and diodes normally.
You don’t need to use a ½" potentiometer, pretty much any pot with a staggered footprint (shaped like a triangle) will work.
| Part | Package |
|---|---|
| 93PR10KLF | VSSOP8 |
| BAT54S | SOT23 |
Off board - One wire connects to the diode pad on your PWM board, the other connects to the Wiper pad. If the output is full power on 0, simply flip the wired around on the PWM board.
Be sure to follow me on Instagram:
@ApexBoxMods
And check out My eBay store for completed boards!
