RFM9x Breakout Board
author: jasonpax
2 layer board of 1.33 x 1.01 inches (33.9 x 25.6 mm)
Uploaded:
May 30, 2020
Shared:
May 31, 2020
Total Price:
$6.70
NOTE: This board, like all OSHPark boards, will have burrs on it. Since the board is so wide compared to a breadboard, these burrs will prevent jumpers from entering free holes on the breadboard. You will need sandpaper or a rotary tool to remove the burrs.
This is a breakout board for the HopeRF LoRa RFM9x radio modules.
Features
- 50 ohm trace to antenna
- RF guard ring w/ stiching
- Location for RST pullup resistor
- Location for 3V3 bypass capacitor
- Board width is small enough that one row of pins on either side of a breadboard will be available when board is dropped in.
Bill of Materials
- RFM9x module
- Upright SMA connector
- Headers
- 0603 10uF capacitor (optional)
- 0603 100k resistor (optional)
NOTE: This board, like all OSHPark boards, will have burrs on it. Since the board is so wide compared to a breadboard, these burrs will prevent jumpers from entering free holes on the breadboard. You will need sandpaper or a rotary tool to remove the burrs.
This is a breakout board for the HopeRF LoRa RFM9x radio modules.
Features
- 50 ohm trace to antenna
- RF guard ring w/ stiching
- Location for RST pullup resistor
- Location for 3V3 bypass capacitor
- Board width is small enough that one row of pins on either side of a breadboard will be available when board is dropped in.
Bill of Materials
- RFM9x module
- Upright SMA connector
- Headers
- 0603 10uF capacitor (optional)
- 0603 100k resistor (optional)
