Teensy v3.1 - S.Port & WS28xx Led Shield

By irun4fundotca

2 layer board of 1.43 x 1.00 inches (36.2 x 25.4 mm).
Shared on November 20th, 2014 22:54

Teensy v3.1 - S.Port & WS28xx Led Shield

Pic: Pic

-Allows for Smart Port Sensors to chain from the servo connector pins (marked) using arduino & serial monitor to log data info:

http://www.rcgroups.com/forums/showthread.php?t=2245978

-=The only power that’s needed is usb while chaining sensors=- Disconnect Board Power while USB connected and vice versa

-Working on teensy code for outputting data to onboard telemetry radio port

-Addressable led output to run led code if implemented for gps lock ect

-cut trace resistor(1k) pad for led output

-end mount 1000uf Capacitor pads for mounting

if any errors found email me at: lakins.c@gmail.com

$7.10 for three


Teensy v3.1 - S.Port & WS28xx Led Shield

By irun4fundotca

2 layer board of 1.43 x 1.00 inches (36.2 x 25.4 mm).
Shared on November 20th, 2014 22:54

Teensy v3.1 - S.Port & WS28xx Led Shield

Pic: Pic

-Allows for Smart Port Sensors to chain from the servo connector pins (marked) using arduino & serial monitor to log data info:

http://www.rcgroups.com/forums/showthread.php?t=2245978

-=The only power that’s needed is usb while chaining sensors=- Disconnect Board Power while USB connected and vice versa

-Working on teensy code for outputting data to onboard telemetry radio port

-Addressable led output to run led code if implemented for gps lock ect

-cut trace resistor(1k) pad for led output

-end mount 1000uf Capacitor pads for mounting

if any errors found email me at: lakins.c@gmail.com

$7.10 for three