MicroMacSoundController
2 layer board of 1.61 x 0.94 inches (41.0 x 24.0 mm)
Uploaded:
March 26, 2026
Shared:
March 30, 2026
Total Price:
$7.60
The custom board does the following for the Micro Macintosh pi project when ATTiny is programmed:
• Mutes all of the Bluetooth power on, connect/disconnect sounds by way of GPIO signals from the pin and timers so you only here the MAC sounds during startup, running and shutdown.
• plays disk i…
Show full description
The custom board does the following for the Micro Macintosh pi project when ATTiny is programmed:
• Mutes all of the Bluetooth power on, connect/disconnect sounds by way of GPIO signals from the pin and timers so you only here the MAC sounds during startup, running and shutdown.
• plays disk i…
Show full description
Nixie Controller - Final
2 layer board of 1.62 x 1.68 inches (41.1 x 42.6 mm)
Uploaded:
April 26, 2021
Shared:
May 05, 2021
Total Price:
$13.55
Controls 2 nixie tubes form an Arduino Pro Micro. Has high voltage transistor output pin for decimal or other device and SPI input for accelerometer etc… Requires high voltage supply.
Controls 2 nixie tubes form an Arduino Pro Micro. Has high voltage transistor output pin for decimal or other device and SPI input for accelerometer etc… Requires high voltage supply.
Tiny Arcade Timer
2 layer board of 0.69 x 0.80 inches (17.5 x 20.3 mm)
Uploaded:
January 28, 2018
Shared:
March 01, 2018
Total Price:
$2.75
Keeps the tiny arcade in demo mode.
BOM: 1k resistor. 470k resistor. 555 timer. 40nf capacitor.
Connect pad labeled "1" to Ground. Connect pad labeled "2" to Power. Connect pad labeled "3" to "try me" button pin on main board.
Keeps the tiny arcade in demo mode.
BOM: 1k resistor. 470k resistor. 555 timer. 40nf capacitor.
Connect pad labeled "1" to Ground. Connect pad labeled "2" to Power. Connect pad labeled "3" to "try me" button pin on main board.
