Hey there! Before ordering, make sure you have all all the info you need to complete and use this design.
This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended.
OSH Park cannot place any guarantees about the functionality or correctness of the design.
Hey there! Before ordering, make sure you have all all the info you need to complete and use this design.
This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended.
OSH Park cannot place any guarantees about the functionality or correctness of the design.
2 layer board of 4.18 x 3.38 inches (106.1 x 85.8 mm)
Uploaded:
May 26th 2016
Shared:
June 9th 2016
Total Price:
$70.50
Ampeg 70's V4B vintage power supply, nodes A, B, C, D, and E.
This is a general purpose design that allows two options for connecting node B. R55 spacing …
Ampeg 70’s V4B vintage power supply, nodes A, B, C, D, and E.
This is a general purpose design that allows two options for connecting node B. R55 spacing allows for one 10W 470Ω resistor or two parallel 5W 1KΩ resistors, one on the top of the board, the other on the bottom.
Sized for Nichicon GW and GX series snap-in capacitors.
Mounted with 4-40 screws on one inch hex standoffs. Uses the four existing cap can mounting holes so the chassis does not have to be modified.
Ampeg 70's V4B vintage power supply, nodes A, B, C, D, and E.
This is a general purpose design that allows two options for connecting node B. R55 spacing …
Ampeg 70’s V4B vintage power supply, nodes A, B, C, D, and E.
This is a general purpose design that allows two options for connecting node B. R55 spacing allows for one 10W 470Ω resistor or two parallel 5W 1KΩ resistors, one on the top of the board, the other on the bottom.
Sized for Nichicon GW and GX series snap-in capacitors.
Mounted with 4-40 screws on one inch hex standoffs. Uses the four existing cap can mounting holes so the chassis does not have to be modified.
Hey there! Before ordering, make sure you have all all the info you need to complete and use this design.
This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended.
OSH Park cannot place any guarantees about the functionality or correctness of the design.
Hey there! Before ordering, make sure you have all all the info you need to complete and use this design.
This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended.
OSH Park cannot place any guarantees about the functionality or correctness of the design.
Hey there! Before ordering, make sure you have all all the info you need to complete and use this design.
This usually means a component list, and sometimes additional information such as assembly notes, source code, or usage guides.
Since this is a project designed by a community member, it may contain design errors that prevent it from working as intended.
OSH Park cannot place any guarantees about the functionality or correctness of the design.
