2 layer board of 0.71 x 0.67 inches (18.0 x 17.0 mm)
Uploaded:
January 15th 2020
Shared:
January 15th 2020
Total Price:
$2.35
The KN13 MinasTirith 1.0 is meant to help simplify the creation of BLE 4.0 iBeacons based on HM-10 modules with ZS-040 or similar breakout boards. Note that while connected to the KN13-MT01.0 only the GND and VCC pins of the ZS-040 module are used. It should be noted that it is not intended for t…
The KN13 MinasTirith 1.0 is meant to help simplify the creation of BLE 4.0 iBeacons based on HM-10 modules with ZS-040 or similar breakout boards. Note that while connected to the KN13-MT01.0 only the GND and VCC pins of the ZS-040 module are used. It should be noted that it is not intended for the ZS-040 module to be soldered to the pins on this board (though you may do so if you wish) but rather that the module be connected to a female pin header to ensure that it remains removable in case you wish to reconfigure it in the future.
To use this board for its intended purpose:
(1) Solder a 6-pin female header and a 3-pin CR2032 coin cell holder to the board in the appropriate locations
(2) Insert an HM-10 with a ZS-040 or similar breakout board (e.g. AT-09, JDY-09, etc) that has been configured as an iBeacon into the female headers following the orientation written on the board
(3) Insert a lithium CR2032 coin cell battery into the coin holder
(4) Use a beacon scanning app to verify that your beacon is working correctly
Show full description
The KN13 MinasTirith 1.0 is meant to help simplify the creation of BLE 4.0 iBeacons based on HM-10 modules with ZS-040 or similar breakout boards. Note that while connected to the KN13-MT01.0 only the GND and VCC pins of the ZS-040 module are used. It should be noted that it is not intended for t…
The KN13 MinasTirith 1.0 is meant to help simplify the creation of BLE 4.0 iBeacons based on HM-10 modules with ZS-040 or similar breakout boards. Note that while connected to the KN13-MT01.0 only the GND and VCC pins of the ZS-040 module are used. It should be noted that it is not intended for the ZS-040 module to be soldered to the pins on this board (though you may do so if you wish) but rather that the module be connected to a female pin header to ensure that it remains removable in case you wish to reconfigure it in the future.
To use this board for its intended purpose:
(1) Solder a 6-pin female header and a 3-pin CR2032 coin cell holder to the board in the appropriate locations
(2) Insert an HM-10 with a ZS-040 or similar breakout board (e.g. AT-09, JDY-09, etc) that has been configured as an iBeacon into the female headers following the orientation written on the board
(3) Insert a lithium CR2032 coin cell battery into the coin holder
(4) Use a beacon scanning app to verify that your beacon is working correctly
Show full description
