Shared Projects by PeskyProducts

LSM9DS0 9-axis motion sensor plus LPS25H pressure sensor with the SENtral EM7180 sensor fusion hub with M24512DFM EEPROM to store the SENtral configuration file. SENtral takes 9-axis accel/gyro/mag from LSM9DS0 and performs hardware sensor fusion returning raw data, quaternions, linear acceleration, and heading, etc. Breakout board using the SENtral with jumpers to take power from edge pins for breadboard use or to mount directly on the Teensy 3.1 for comparison between open-source software sensor fusion and the hardware sensor fusion provided by the SENtral. SENtral can act as master to LPS25H pressure sensor and in the future include the pressure data in the sensor fusion.

LSM9DS0 9-axis motion sensor plus MS5637 pressure sensor with the SENtral EM7180 sensor fusion hub with M24512DFM EEPROM to store the SENtral configuration file. SENtral takes 9-axis accel/gyro/mag from LSM9DS0 and performs hardware sensor fusion returning raw data, quaternions, linear acceleration, and heading, etc. Breakout board using the SENtral with jumpers to take power from edge pins for breadboard use or to mount directly on the Teensy 3.1 for comparison between open-source software sensor fusion and the hardware sensor fusion provided by the SENtral.

Bosch’s new BNO-055 9-axis motion sensor plus MS5637 pressure sensor. The BNO-055 has an embedded Cortex M0 ARM processor as well as accel/gyro and mag for a purely hardware absolute orientation solution. This is either a mini Teensy 3.1 shield or a conventional breakout board, choice is made via solder pads on back which bring 3V3 and GND out to edge pins. Sensor can be accessed either via I2C, UART, or HID-I2C on Windows 8 by changing solder pads PS0 and PS1 on back. Lastly, BNO-055 I2C address LSB can be changed via solder pad ADO so two can be on the same circuit, if desired. Added boot pin breakout.

Breakout board with two independently addressable ST Microelectronics' 2 Mbit (256 kbyte) M24M02-DRC I2C EEPROMs designed to be mounted onto the Teensy 3.1 and use digitalWrite for power and ground due to the very low-power (< 2 mA per EEPROM) requirements. Can also be used as a traditional breakout board since VIN ranges from 1.8 to 5.5 V. Cutting one or both traces between the solder jumpers enables write protect mode allowing access to the data already written but disallowing further write operations. The write protect is reversible by simply soldering the junction again. Operating temperature range is -40 C to +85 C making this an ideal solution for portable/remote data logging when power and space are at a premium. EEPROM write operational for 4 million write cycles and data is retained for 200 years! Minimized width to make it even more appallingly small! Fixed trace error!

Nanoscopic breakout board for MPU9250 motion sensor hardwired for I2C and ADO=1 to serve as auxiliary motion sensor to support more conventional Mini and/or Micro add-on boards when one MPU9250 just isn’t enough. I2C pullup resistors can be added if they are the only ones in the circuit; usually these will be unoccupied.