Shared Projects by IntergatedCircuits

Cheap open-source full-featured CAN bus traffic analyzer.

Repository

The schematic and the embedded firmware for the onboard STM32 chip are available on GitHub.

Bill of Materials

(All passive components and LEDs are 0603 footprint, italics indicate optional features.)

• USB-Micro-B connector
• 2 x 100 mil header CAN / 4 x 100 mil header CAN + 5V
• 5 x 50 mil header SWD programming interface
• U1: TPD3S014DBVR (for USB ESD protection and transceiver power control) - alternatively short JP1, or power the transceiver via external 5V
• U2: TPS70933DBVR or equivalent (5Vin 3.3Vout 100mA LDO)
• U3: STM32F042C6T6 or equivalent (USB+CAN)
• U4: TPD2E009DBZR (for CAN ESD protection)
• U5: SN65HVD255DR or equivalent (any SOIC-8 CAN transceiver)
• D3: 5.6V Zener diode SOD-323 (only if 5V power isn’t from USB)
• X1: 3.2 x 2.5 mm 8/12 MHz quartz
• C3, C4: 22pF (quartz load capacitors)
• C1, C11: 1uF
• D1, D2: frame and error indicating LED (e.g. green and red)
• R5, R6: adjust according to desired LED current
• C5, C6, C7, C8, C9, C10: 100nF
• R7, R8 depend on the CAN transceiver, typically R7 = 0
• R1: 1.5kO (only if STM32F1 or STM32F3 series is used)
• R4: 1MO
• C2: 10nF

BOM

• 1 x TI LMX9838 Bluetooth module
• 3 x 100nF 0603 capacitor (Top, upper left)
• 2 x 7 pin 100mil header

  Optional:

• 2 x 0603 LED (Top, round pad = cathode)
• 2 x 0603 resistor for LEDs (Bottom, same horizontal position)
• 3 x 1kOhm 0603 resistor for baudrate setting (Bottom, same horizontal position)
• 1 x 0Ohm 0603 resistor for flow-control-less UART (Top, no silk pads)

The PCB is 100mil breadboard insertable