Shared Projects by BennitoJuarez

Shared Projects by BennitoJuarez

Vpin Molex Breakout_2023-12-03

2 layer board of 1.47 x 2.46 inches (37.3 x 62.5 mm)
Uploaded: December 03, 2023
Shared: December 04, 2023
Total Price: $18.05

13 pin Molex breakout board designed specifically for Bally's / Williams style coin doors with coin button LEDs. Designed for mechanical and virtual pinball machines, or other arcade machines that utilize this coin door that would require a retrofit solution for old or DIY projects. Allows interc…

Show full description

13 pin Molex breakout board designed specifically for Bally's / Williams style coin doors with coin button LEDs. Designed for mechanical and virtual pinball machines, or other arcade machines that utilize this coin door that would require a retrofit solution for old or DIY projects. Allows interc…

Show full description

Embeddable link to order this shared Project

FORD Vehicle Auxiliary Aftermarket Head Unit & Ambient Lighting Controller - Arduino Shield.

2 layer board of 2.72 x 2.12 inches (69.0 x 53.8 mm)
Uploaded: April 30, 2017
Shared: May 01, 2017
Total Price: $28.75

Auxiliary controller shield for aftermarket head units. Requires Arduino compatible microcontroller.

For use with turning on Ford factory installed subwoofer amplifiers that use 5V remote switching instead of the 12v supplied by aftermarket head units. Also adds ambient lighting controls and …

Show full description

Auxiliary controller shield for aftermarket head units. Requires Arduino compatible microcontroller.

For use with turning on Ford factory installed subwoofer amplifiers that use 5V remote switching instead of the 12v supplied by aftermarket head units. Also adds ambient lighting controls and …

Show full description

Embeddable link to order this shared Project

Sparkfun Compatible 2x2 Button Pad.brd

2 layer board of 1.97 x 1.97 inches (50.0 x 50.0 mm)
Uploaded: January 02, 2017
Shared: January 02, 2017
Total Price: $19.35

Button pad to replace the standard Sparkfun 2x2 button board. This board uses addressable LEDs with the WS2812 control IC built-in. (NOTE: diodes are only needed for multiple-board matrices, otherwise just use jumper wires).

BOM

[Sparkfun 2x2 ButtonPad, LED compatible](https://www.sparkf…

Show full description

Button pad to replace the standard Sparkfun 2x2 button board. This board uses addressable LEDs with the WS2812 control IC built-in. (NOTE: diodes are only needed for multiple-board matrices, otherwise just use jumper wires).

BOM

[Sparkfun 2x2 ButtonPad, LED compatible](https://www.sparkf…

Show full description

Embeddable link to order this shared Project

NavLights Shield v1.0

2 layer board of 1.80 x 1.80 inches (45.7 x 45.7 mm)
Uploaded: December 27, 2013
Shared: December 27, 2013
Total Price: $16.20

RC RGB LED Strip Controller - Arduino Micro. Used to control LED RGB Strips by using one pin (serial data). Used mainly for multi-rotors and aircraft for night flying. Also breaks out the I/O pins for sensors and such.

RC RGB LED Strip Controller - Arduino Micro. Used to control LED RGB Strips by using one pin (serial data). Used mainly for multi-rotors and aircraft for night flying. Also breaks out the I/O pins for sensors and such.

Embeddable link to order this shared Project